Skills of disassembly and assembly of outer spherical bearing

Technical points and precautions of outer spherical bearing:
1、 Dismantle
1. First loosen the locking screw on the bearing eccentric sleeve with an Allen wrench, then insert a small iron rod into the counterbore on the top cover eccentric sleeve, and loosen the eccentric sleeve against the rotation direction of the shaft.
2. Loosen the bolts fixing the bearing seat. Remove the bearing together with the bearing pedestal from the shaft. Before removing the bearing seat at one end of the shaft, loosen the bolts of the bearing seat at the other end of the shaft to avoid damage to the bearings at both ends.
2、 Installation
1. Before installing the bearing on the shaft, the fixing pin of the bearing sleeve must be pulled out, the surface of the journal must be polished smooth and clean, and the journal shall be coated with oil for rust prevention and lubrication (the bearing is allowed to rotate slightly on the shaft).
2. Apply lubricating oil on the mating surface of bearing seat and bearing, and install the bearing into the bearing seat. Then sleeve the assembled bearing and bearing seat on the shaft. Push it to the required position for installation.
3. Do not tighten the bolts fixing the bearing seat first, and make the bearing sleeve rotate in the bearing seat. Similarly, install the bearing and seat at the other end of the same shaft, rotate the shaft for several turns, and let the bearing itself automatically align. Then fasten the bearing seat bolts.
4. Install eccentric sleeve. First put the eccentric sleeve on the eccentric step of the bearing inner sleeve and tighten it by hand along the rotation direction of the shaft. Then insert or counter the small iron rod into the counterbore on the eccentric sleeve. Knock the small iron rod along the rotation direction of the shaft with a hammer to make the eccentric sleeve firmly installed. Finally, lock the Allen screw on the eccentric sleeve.